An investigation of the electrochemical oxidation of glycerol as alternative fuel to hydrogen and methane in a solid oxide fuel cell (SOFC) based on a noble metal-free anode catalyst was carried out. The anode electrocatalyst consisted of a Ni-modified La0.6Sr0.4Fe0.8Co0.2O3 (LSFCO) perovskite. After thermal activation, air treatment at 1100°C followed by reduction at 800°C in H2, Ni was mainly present as ultrafine La2 NiO4 particles homogeneously dispersed on the perovskite surface. The thermal activation also caused a modification of perovskite into a lanthanum depleted structure. The thermal reduction at 800°C determined the occurrence of metallic Ni on the surface. These results were corroborated by X-ray photoelectron spectroscopy (XPS), transmission electron microscopy (TEM) and X-ray diffraction (XRD). A suitable power density (327 mW cm-2) was achieved for the electrolyte supported SOFC fed with chemical-grade glycerol in almost dry condition, i.e. steam to carbon ratio (S/C) of 0.2. The highest electrical efficiency (voltage efficiency) approached 50% at the peak power under mild humidification (S/C = 0.2). Whereas an increase of water to glycerol ratio, caused a progressive decrease of voltage efficiency at the peak power down to 44% for S/C = 2.
Physico-chemical and electrochemical properties of Ni perovskite solid oxide fuel cell anode for glycerol oxidation
-
2012
Abstract
An investigation of the electrochemical oxidation of glycerol as alternative fuel to hydrogen and methane in a solid oxide fuel cell (SOFC) based on a noble metal-free anode catalyst was carried out. The anode electrocatalyst consisted of a Ni-modified La0.6Sr0.4Fe0.8Co0.2O3 (LSFCO) perovskite. After thermal activation, air treatment at 1100°C followed by reduction at 800°C in H2, Ni was mainly present as ultrafine La2 NiO4 particles homogeneously dispersed on the perovskite surface. The thermal activation also caused a modification of perovskite into a lanthanum depleted structure. The thermal reduction at 800°C determined the occurrence of metallic Ni on the surface. These results were corroborated by X-ray photoelectron spectroscopy (XPS), transmission electron microscopy (TEM) and X-ray diffraction (XRD). A suitable power density (327 mW cm-2) was achieved for the electrolyte supported SOFC fed with chemical-grade glycerol in almost dry condition, i.e. steam to carbon ratio (S/C) of 0.2. The highest electrical efficiency (voltage efficiency) approached 50% at the peak power under mild humidification (S/C = 0.2). Whereas an increase of water to glycerol ratio, caused a progressive decrease of voltage efficiency at the peak power down to 44% for S/C = 2.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
