In this work, blends of a difunctional epoxy monomer and a thermoplastic toughening agent are E-beam irradiated at two different dose rates and two different total absorbed doses. The influence of the processing conditions on the thermal properties and on the morphology of the obtained matrices has been investigated. In particular, it is shown how the increase of the dose rate causes an increase of the temperature during irradiation, thus inducing a simultaneous thermal and radiation curing. On the contrary, at low-dose rate the system mainly undergoes to radiation curing, thus making the cured material very sensible to a post-irradiation thermal treatment with a significant improvement of the thermal properties. © 2007 Elsevier Ltd. All rights reserved.
E-beam curing of epoxy-based blends in order to produce high-performance composites
Lavalle M;
2007
Abstract
In this work, blends of a difunctional epoxy monomer and a thermoplastic toughening agent are E-beam irradiated at two different dose rates and two different total absorbed doses. The influence of the processing conditions on the thermal properties and on the morphology of the obtained matrices has been investigated. In particular, it is shown how the increase of the dose rate causes an increase of the temperature during irradiation, thus inducing a simultaneous thermal and radiation curing. On the contrary, at low-dose rate the system mainly undergoes to radiation curing, thus making the cured material very sensible to a post-irradiation thermal treatment with a significant improvement of the thermal properties. © 2007 Elsevier Ltd. All rights reserved.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
