Post combustion CO2 capture with calcium and lithium hydroxide

A small-scale plant was built for measuring the ability of solid sorbents towards the capture of carbon dioxide (CO) in exhaust flue gas from an internal combustion engine. The investigated sorbents were calcium and lithium hydroxides. Both sorbents are low cost and used in the breathing gas purification systems. The carbonation capacity of each sorbent was measured for different sorbent granulometry (pellets and powder), different temperature (from ambient up to 300 °C), gas space velocity, moisture content and chemical composition of the gaseous stream. The aim was, in fact, to expose the sorbents to a gas stream with chemical and physical parameters close to those at the exhaust of an internal combustion engine. Carbonation capacity was measured with a double technique: on-line by continuously CO measurement with a non-dispersive infrared analyzer and off-line by using scanning electron microscopy on carbonated sorbents. Experimental results showed good CO uptake capacity of calcium hydroxide at low temperature (between 20 and 150 °C). Performance improvements came from the fine granulometry due to the increased exposed surface area; moreover, the presence of the moisture in gas stream also enhanced CO capture. The presence of sulphur dioxide and nitric oxide, instead, greatly decreased the carbonation capacity of sorbents.