: Formation condition and annealing kinetics of self-interstitial (I) clusters in. ion implanted Si have been investigated. Deep level transient spectroscopy (DLTS) and photoluminescence (PL) measurements were performed on both p-type Czochralski Si samples implanted with Si ions at energies ranging from 40 KeV to 1.2 MeV. They reveal that I-clusters form for implantation fluences above 10(12) cm(-2) and annealing temperatures higher than 550 degrees C. Analysis of the annealing kinetics at temperatures in the range 550-700 degrees C reveals that I-clusters dissociate with an energy depending on the implantation dose. The characteristic dissociation energy is similar to 2.3 eV for 1 x 10(12) cm(-2) implants, and this value increased towards the typical {311} extended defects dissociation energy value (similar to 3.8 eV) by increasing the implantation fluence. Finally, the transition from I-clusters to (311) defects was followed using PL and DLTS in combination with transmission electron microscopy analysis. A PL line at 1375 nm has been associated to (311) extended defects and a threshold dose and annealing temperature for the extended defects formation identified.
Cluster formation and growth in Si ion implanted c-Si
S Libertino;C Spinella;
2000
Abstract
: Formation condition and annealing kinetics of self-interstitial (I) clusters in. ion implanted Si have been investigated. Deep level transient spectroscopy (DLTS) and photoluminescence (PL) measurements were performed on both p-type Czochralski Si samples implanted with Si ions at energies ranging from 40 KeV to 1.2 MeV. They reveal that I-clusters form for implantation fluences above 10(12) cm(-2) and annealing temperatures higher than 550 degrees C. Analysis of the annealing kinetics at temperatures in the range 550-700 degrees C reveals that I-clusters dissociate with an energy depending on the implantation dose. The characteristic dissociation energy is similar to 2.3 eV for 1 x 10(12) cm(-2) implants, and this value increased towards the typical {311} extended defects dissociation energy value (similar to 3.8 eV) by increasing the implantation fluence. Finally, the transition from I-clusters to (311) defects was followed using PL and DLTS in combination with transmission electron microscopy analysis. A PL line at 1375 nm has been associated to (311) extended defects and a threshold dose and annealing temperature for the extended defects formation identified.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.