Hafnium diboride (HfB2)- and hafnium carbide (HfC)-based materials containing MoSi2 as sintering aid in the volumetric range 1%-9% were densified by spark plasma sintering at temperatures between 17501 and 1950°C. Fully dense samples were obtained with an initial MoSi2 content of 3 and 9 vol% at 17501-1800°C. When the doping level was reduced, it was necessary to raise the sintering temperature in order to obtain samples with densities higher than 97%. Undoped powders had to be sintered at 21001-2200°C. For doped materials, fine microstructures were obtained when the thermal treatment was lower than 1850°C. Silicon carbide formation was observed in both carbideand boride-based materials. Nanoindentation hardness values were in the range of 25-28 GPa and were independent of the starting composition. The nanoindentation Young's modulus and the fracture toughness of the HfB2-based materials were higher than those of the HfC-based materials. The flexural strength of the HfB2-based material with 9 vol% of MoSi2 was higher at 1500°C than at room temperature.
Densification and mechanical behavior of HfC and HfB2 fabricated by Spark Plasma Sintering
Diletta Sciti;Stefano Guicciardi o Guizzardi;
2008
Abstract
Hafnium diboride (HfB2)- and hafnium carbide (HfC)-based materials containing MoSi2 as sintering aid in the volumetric range 1%-9% were densified by spark plasma sintering at temperatures between 17501 and 1950°C. Fully dense samples were obtained with an initial MoSi2 content of 3 and 9 vol% at 17501-1800°C. When the doping level was reduced, it was necessary to raise the sintering temperature in order to obtain samples with densities higher than 97%. Undoped powders had to be sintered at 21001-2200°C. For doped materials, fine microstructures were obtained when the thermal treatment was lower than 1850°C. Silicon carbide formation was observed in both carbideand boride-based materials. Nanoindentation hardness values were in the range of 25-28 GPa and were independent of the starting composition. The nanoindentation Young's modulus and the fracture toughness of the HfB2-based materials were higher than those of the HfC-based materials. The flexural strength of the HfB2-based material with 9 vol% of MoSi2 was higher at 1500°C than at room temperature.File | Dimensione | Formato | |
---|---|---|---|
prod_43498-doc_7525.pdf
solo utenti autorizzati
Descrizione: Densification and mechanical behavior of HfC and HfB2 fabricated by Spark Plasma Sintering
Tipologia:
Versione Editoriale (PDF)
Licenza:
NON PUBBLICO - Accesso privato/ristretto
Dimensione
782.81 kB
Formato
Adobe PDF
|
782.81 kB | Adobe PDF | Visualizza/Apri Richiedi una copia |
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.